Aircraft Battery Accessories
CA1550 Charger/Analyzer
Part No. 4159
53 lbs. For Lead Acid and Nickel Cadmium Batteries.
12/24V constant current or constant potential charger. Discharge from 0-50A, Charge at 0-25A. VAC in: 115-230 adj.
Mode of Operation:
Discharge:
Select Mode - Set test time. Connect battery to be tested and turn AC switch on.
Press start and adjust current to test rate.
Displays show elapsed time, voltage and current. Meters show rate of discharge, end of discharge voltage, and timer shows total elapsed time. Voltmeter shows end-point, voltage, timer shows elapsed time. Displays hold test data until reset.
Charge:
Select Mode - Constant Potential of Constant Current. Connect battery. Set timer. Select charging voltage. Turn AC switch on, voltmeter reads open circuit voltage of battery. Press start and adjust charge current. In Constant Potential (voltage) mode, charge current will taper as the battery voltage rises.
Intelligent design and simple operation.
Adjustable constant current discharge from 0 to 50 amperes.
Adjustable cutoff voltage.
Green light illuminates when battery passes preset test.
Red light illuminates when battery fails preset test.
Digital meters record end of discharge readings for elapsed time, ampere rate, and en-point voltage.
Audible signal at the end of test.
Constant potential charge.
Constant current charge.
Charge at 0 to 25 amps.
Digital ammeter, voltmeter, timer, and ampere hour meter.
Preset time limit for charge with digital electronic display.
Low ripple charge.
| P/N | Comment | |
4159 |
CA-1550 24-Volt Aircraft Battery Charger/Analyzer
For both Lead Acid and Nickel Cadmium Types |
| |
The data/information contained herein has been reviewed and approved for
general release on the basis that this document contains no
export-controlled information. |
|
